**UPDATED 1/2/09**

   I haven’t used this design for some time, but I’ve always liked it. I came up with it when I lived in New Mexico. Since I moved down south, I’ve not had an opportunity to use it, but I came across it recently and decided to add it to the site.

    In addition to the two slabs shown below, you’ll need a base piece that’s at least 20”x10”x4”. The bottle shown is typically rather flat, but you can round it out some if you use thicker ice. Make sure to get as clean a weld as possible between the bottle parts. If the spray piece doesn’t attach cleanly to the sign piece, use a small handsaw to adjust the weld surfaces.

  If you would like to use this design or any other design on this site, please check the design usage guidelines. The design collection page lists designs on the site.